|
Directions For Use.
Things You’ll Need
- Clean
bucket and wringer.
-
Wet Mop - Cotton and Rayon
will both work well - Microfiber
works great!
- High speed
floor machine (burnisher)
1500 -2000 rpm
-
Floor
pads: Select from any of the
light-medium aggressive Natural
Blend Hair pads.
Preparation and
Application
Select a floor with a good floor
finish base, 3-4 coats is optimal.
The more finish, the better the
result. (Top Guard works equally
well on all flooring types providing
there is enough finish, VCT,
Terrazzo, Marble, Pirelli, Ceramic,
etc.) Top Guard can be applied to
the floor two ways. Dilute according
to application preference:
Damp Mopping –
Fill Mop bucket with 1 gallon of
cold water. (If unsure of amount,
use an empty gallon container to
help measure.) – Squeeze Top Guard
bottle to fill the chamber with two
(2) ounces of Top Guard and pour
into bucket.
Spray Bottle – Squeeze Top Guard
bottle to fill the chamber with one
(1) ounce of Top Guard and pour into
spray bottle. Fill spray bottle to
top with cold water.
Application
Instructions
Damp Mopping: Wring out the mop
well. Top Guard should be applied to
the floor a bit thinner than a coat
of floor finish.
Spray Bottle: Slowly swing your arm
from side to side spraying Top Guard
from the bottle in a stream (not a
spray). Do not worry about applying
Top Guard evenly, the floor pad will
spread the solution evenly over the
floor when burnishing.
Burnishing
Instructions
Top Guard can be burnished Wet or
Dry! When Damp Mopped, allow
approximately 1 minute for Top Guard
to begin to dry and burnish while
still damp for best results. When
applied via spray bottle, begin
burnishing immediately after Top
Guard has been applied to the floor.
*Take your time when burnishing for
the first few times for a stronger,
deeper shine.
Make a date to
come back and evaluate your new Top
Guard floor after the day’s traffic
– compare the Top Guard results to
your usual method with your existing
product. The difference is Top
Guard!
Things to Look
for While Using Top Guard
Top Guard enhances the slip
coefficient of the floor. Walk on
the floor while it is wet and take
note of how non-slip the floor
appears.
When dry, test the slip resistance
of the floor ….. Incredible.
Make special note of the gloss. It’s
deep and water clear, not hazy like
polymer based restorers.
Top Guard is the
only Finish Enhancement product that
eliminates the dust created from
burnishing (even with propane).
Remember to look at the bottom of
the floor pad… There’s no white
ring, no build-up. The finish that’s
on the floor stays on the floor!
|
