|
 |
Ultra HIGH Speed Floor Finish
Designed specifically for the professional that requires unsurpassed "WET LOOK" gloss with excellent durability.
Mirage Floor Finish is ideally suited for use in supermarkets, schools, hospitals and offices where
there is a demand for toughness and durability.
For use on: Vinyl, Vinyl Composition, Asphalt, Rubber, Concrete, Flagstone,
Brick, Terrazzo, Sealed Wood, and Quarry Tile.
New chemistry allows the finish to dry absolutely crystal clear, allowing the beauty of the underlying floor to shine through.
Simple to apply and maintain. Response is unsurpassed with any type of high-speed equipment
(propane,
battery, or
cord electric). |
Preparation:
If stripping is necessary, use a high quality stripper and follow directions accordingly. If floor is in good condition and stripping is not necessary, sweep up excess dirt and dust and then clean with a good quality cleaner to remove dirt and oils. Follow with a thorough rinsing and allow to dry completely.
Finishing:
Apply 2 or 3 even coats of finish using a
clean finish
mop. Allow a minimum of 20 minutes dry time between coats. Apply additional coat to obtain desired gloss.
Burnishing:
Dust mop or sweep thoroughly. Clean floor with a
neutral floor cleaner diluted according to directions. Burnish using the
appropriate pads.
Restoration:
Dust mop or sweep thoroughly. Dilute restorer according to directions and apply to floor with clean mop or auto-scrubber. Allow to dry to a haze and buff out with any type of high-speed equipment-propane, battery, or cord electric.
Recoating:
Dust mop or sweep thoroughly. Deep scrub using a neutral floor cleaner diluted according to directions. Apply 1 or 2 even coats of finish using a clean finish mop.
|
