Wood Floor Finish Removal Tool

Wood Floor Finish & Coating Removal Tool

The Wood Floor Coating Removal Tool is the first step to rejuvenate hardwood floors. The Wood Floor Sanding & Prep Tool is designed to remove polyurethane coatings, felt paper and carpet adhesive from hardwood floors, effectively preparing the floor for refinishing. The diamond cutting surface remains free of melted or gummed up coatings and retains its sharp cutting points throughout the life of the tool. No more wasted time or money changing caramelized sandpaper.

Refinishing hardwood floors starts with the Wood Floor Prep Tool. This tool mounts to any standard speed floor buffer and uses diamond coated blades to grind tough coatings away. A clutch plate is supplied at no-charge and fits the majority of floor machines used today.

Order #1131615

Wood Floor Prep Tool (15")

Add/Qty	Price	Pack	Unit

Order #1131600

Replacement Blades (6)

Add/Qty	Price	Pack	Unit

The wood floor preparation tool is 15" in diameter. This will fit the majority of 17" floor machines and is the largest size available.

The Wood Floor Prep Tool is designed to remove polyurethane and carpet adhesive from hardwood floors, effectively preparing the floor for refinishing.

50 Grit Diamond embedded metal blades
Replaces conventional sandpaper used to remove heavy coatings
Blades are reversible using a five thirty seconds inch Allen Wrench to remove, and flip.
Included with each Wood Floor Tool is a hand brush for cleaning debris from the blades after use, and an Operator Instruction Guide.

Use with 1.5 hp standard speed (low speed) floor buffer of 175 RPM
Rotation sensitive, is set for standard counter clockwise rotation on most floor machines.
Depending on the condition of the floor, blade wear is approximately 1,000 to 2,000 sq. ft. per set
This tool is used DRY requires no water

Removes polyurethanes, varnishes and even hard to remove coatings such as carpet or tile glue residue left on a previously covered wood floor.

Designed to fit easy-to-use rotary sanders versus difficult to use drum (belt) sanders

Rigid, exposed diamond cutting surface creates a perfectly level floor with normal use.

Removes unwanted low spots and gaps between floor boards to save users significant time during later sanding steps.

Low-profile design enables the tool to travel seamlessly over heat registers carved out in the floor