| Preparation: If
stripping is necessary, use a high quality stripper and follow
directions accordingly. If floor is in good condition and
stripping is not necessary, sweep up excess dirt and dust and
then clean with a good quality cleaner to remove dirt and oils.
Follow with a thorough rinsing and allow floor to dry
completely. Finishing: Apply 3 or 4 liberal coats of seal and finish
using a clean mop. Allow a minimum of 45 minutes drying time
between coats. Apply additional coat to obtain desired gloss.
Burnishing: Dust mop or sweep thoroughly. Clean floor
with a neutral floor cleaner diluted according to directions.
Burnish using the appropriate pads.
Restoration: Dust mop or sweep thoroughly. Dilute
restorer according to manufacturers direction and apply to floor
with clean mop or auto-scrubber. Allow to dry to a haze and buff
out with any type of UHS equipment-propane, battery, or
electric.
Recoating: Dust mop or sweep thoroughly. Deep scrub using
a neutral floor cleaner diluted according to directions. Apply 1
or 2 liberal coats of finish using a clean mop. |
