A low odor ultra concentrated (1:20) high-powered
floor stripper that rapidly penetrates and strips off floor finish.
A powerful solvent combined with amines, penetrates and removes
multiple coats of burnished finish with minimum labor. Low odor
formula is ideal for use in areas where odors are a concern.
This high productivity floor stripper removes
floor finishes completely with One Pass and requires no neutralizer.
This unique formula provides the lowest end-use cost per gallon due
to its ultra concentration.
Features:
Ultra Concentrated (1:20)
1 quart of One Pass makes 5 gallons of
Ready To Use Stripper
One Pass Concentrated Floor
Stripper
Specifications
Container Size:
Quart
Physical State:
Liquid
Color:
Light amber
Odor:
Characteristic
Ammoniated:
No
Viscosity:
Water thin
Water Based:
Yes
pH:
11-12 undiluted
Foam:
Very low
Phosphate:
None
Solubility:
Complete with water
Flash Point:
> 200 degrees
Storage / Stability:
2 years
Packaging: Individual quart containers, 12 per case if
ordering by the case.
Areas of Use: Vinyl Tile, Vinyl Asbestos, VCT, Asphalt Tile, Linoleum,
Concrete, Flagstone, Terrazzo, Ceramic Tile.
Directions:
Sweep or dust mop the floor to remove any debris. The desired
concentration will depend on the build-up and age of the polish
film. As a starting point, dilute with cold water or mildly warm
water as follows: 1) Simply add one quart of product to a mop
bucket. Fill the mop bucket with water up to 5 gallons. 2) The
stripping solution may be applied with a mop or automatic scrubber.
Allow to stand for 3 - 5 minutes, scrub with a rotary floor machine
or automatic scrubber equipped with stripping pads. 3) Pick-up the
solution and old finish with a wet vacuum or clean mop. 4) Rinse
thoroughly with clean cold water. 5) Allow floor to dry completely
before applying any floor finish.
Note:
The product must be used only as directed due to its unique
penetrating and liquefying ability. Do not use undiluted product. Do
not dilute with hot water. To determine the optimum use-dilution,
pretest on a small area. Wet floor may become extremely slippery. Be
sure to keep pedestrian traffic away from floor until thoroughly
dry. Work area should have adequate ventilation. since prolonged
exposure to high concentrations of vapors may be harmful to eyes,
skin and respiratory tracts. As prolonged soaking in concentrated
strippers may damage some asphalt tiles, a spot test is recommended
before general use.
DO NOT USE THIS PRODUCT ON WOOD FLOORS OR PAINTED
SURFACES.
