FIBER CLEAN Extraction Cleaner cleans thoroughly and sharpens colors to restore original beauty. Carpet Protector can be sprayed onto the clean carpet to reduce soiling during normal use and the need for frequent cleaning.

Directions For Use:

BEFORE USING ANY SPOTTER OR DETERGENT test a small inconspicuous area for dye stability and/or fabric deterioration. Read carefully all directions and warnings on each container.

Always vacuum carpet thoroughly before spotting or cleaning. Remove furniture from area to be cleaned or place carpet protectors beneath furniture legs - do not remove protectors until carpet is completely dry.

For Self Contained Units

• Mix 2 ounces of FIBER CLEAN per gallon of hot water. Pour this solution into the extractor's clean water tank and proceed with cleaning operation. Make a single pass over a one yard strip of carpet with the spray jets functioning. Go over the same area again using only the suction. Continue this procedure slightly overlapping the previously cleaned area to pick-up over-spray and obtain a uniform streak-free carpet.

For Direct Hook-Up Units

• Pour FIBER CLEAN full strength into machine dispenser. Connect machine to hot water source and to dump site. Start machine and adjust water and product flow so that after cleaning, carpet has a slight slippery feel. Approximately 2 ounces product per 100 square feet of carpeting.

Do Not Over Wet Carpet

• To thoroughly clean heavily soiled carpets, pre-spray with Pre-Treat Plus cleaner. Safe to use on new stain resistant carpet fibers.