|
Clean surface with brush or broom to remove all loose
dirt and debris. If dirt remains scrub area with solution of Neutral
Stone Cleaner.
Remove cleaning solution with a wet vacuum, rinse
thoroughly with clean water.
Allow surface to dry completely before sealing. Sealer
can be applied with paintbrush, pad, roller or mop. Low-pressure pump-up
garden sprayers can also be used for large areas.
Apply at coverage of 150 - 1000 sq ft/gal.
Generously wet the surface, but do not allow puddles to
form. Coverage will depend on the porosity of the stone.
Highly porous surfaces such as cement or concrete will
require two coats. If a second coat is necessary, apply after first coat
has dried for 15 –30 minutes. Clean up all equipment with detergent and
water, immediately after application.
Allow 4 hour to dry before opening area to light traffic.
Maximum performance will be reached in 48-72 hours.
|
