Floor Wax and Finish Stripper - Pour N Peel Floor Stripper

Floor Stripper - Pour N' Peel

Heavy Duty Wax & Floor Finish Stripper

Pour N' Peel is the most effective labor saving stripper ever developed. Virtually eliminates the need for floor machines, pads, and rinsing. It will solubilize aged and built-up finishes and waxes almost instantly.

The ultimate Cold Water Floor Stripper is designed to remove floor finish and sealers from heavily burnisher floors.

Liquefies heavily burnished finish and sealer

May be used as a no-scrub floor stripper or with a conventional floor machine and pad depending on the condition of the floor. Can be sprayed on cove moldings to soften and remove accumulations of old finishes and wax.

Removes water-based concrete sealers from resilient tile, Terrazzo, Flagstone, Vinyl, Ceramic Tile, Asphalt Tile (test first) Rubber (test first) Linoleum, Vinyl Asbestos, Sealed Wood and Concrete floors.

Packaging: One gallon containers or four gallons per case if ordered by the case.

Order #0040601

Pour N' Peel (gallon)

Add/Qty	Price	Pack	Unit

More Information

Floor Care Products

How to Strip Floors

Floor Pads

Pour N' Peel Floor Stripper Specifications
Active Ingredients:	50%
Color:	Clear
Odor:	Sassafras
pH:	13.0 - 13.5
Viscosity:	Water thin
Foam:	Low
Phosphate Content:	None
Solubility:	Complete with water
Emulsification:	Excellent
Detergency:	Excellent
Rinsability:	Excellent
Flash Point:	145 F (TCC)
Biodegradability:	Complete
Storage/Stability:	2 years
Freeze / Thaw Stability:	Keep from freezing

Directions:
The desired concentration will depend on the build-up and age of the polish film. As a starting point dilute with cold water as follows:

On average, 1 gallon of Pour N' Peel floor stripper diluted at 1:4 will coverage approximately 500 square feet.

FOR AVERAGE BUILD-UPS: Dilute 1 to 4 with cold water.
FOR MODERATE BUILD-UPS: Dilute 1 to 3 with cold water.
FOR HEAVY AGED BUILD-UPS: Dilute 1 to 2 with cold water.
FOR USE WITH A FLOOR MACHINE: Dilute 1 to 8-16 parts cold water. Mop a generous solution onto the floor to be stripped. Allow solution to stand about 5 minutes keeping the floor wet at all times. If mop stripping - agitate with the mop. If using an automatic scrubber or rotary floor machine, no mop agitation is required. Pick-up the solution with a wet vacuum, automatic scrubber or clean mop. Allow floor to dry thoroughly prior to applying any sealer or finish. If desired, a rinsing step can be added.

*NOTE: Asphalt tile (usually the old 9" x 9") and rubber or PVC flooring could be affected by stripping solutions in high concentrations. Always test floor before proceeding. If in doubt use pH Neutral Stripper