Wood Floor Recoat Conditioner & Prep Cleaner

NewAge Recoat Conditioner and Prep is a ready to use conditioner/cleaner designed for preparing existing or pre-finished surfaces, prior to the application of our waterborne finishes. Adhesion of the finish will be optimized. Particularly useful for preparing existing sealed sports floors prior to the application of our water base gym finish , where additional contaminants may be present on the surface.

Cleans and conditions existing finish to optimize adhesion of new coat of finish.

• Easy - doesn’t require special training or certification

• Convenient - pre-mixed and ready to use

• Recoat Conditioner and Prep Cleaner removes scuffs and surface scratches, rather than just covering them

• No extra tools needed.

• Minimal dust with a Prep Pad

• Economical

Packaging: One gallon containers or four gallons per case if ordered by the case.

Directions for use:

PRIOR TO USE:
For factory prefinished flooring, contact the manufacturer for specific recoat recommendations.
NOTE: Do not use this product on any floor that has been waxed, polished, oiled or has been maintained with a commercial maintenance coating.

2. WHEN USING A STRING MOP: Apply Recoat Conditioner and Prep Cleaner over 3’ x 24’ sections of the floor at the rate of 2,000 square feet per gallon. Be careful not to apply too heavily. Surface should be damp enough to be slightly wet after abrading using a standard speed (175 rpm) buffer with a Surface Prep Pad (SPP). This cleans the floor to ensure any foreign material is removed, as well as conditions and prepares the old finish to optimize adhesion of the new coat of finish.

WHEN USING AN AUTOSCRUBBER: Set at normal maintenance settings for proper application rate and pad pressure. Use a SPP driven by whatever maintenance pad is typically used.

NOTE: Regardless of the size of area, be sure to overlap sections to ensure that no areas are missed.

3. Remove all residues immediately using a wrung-out cotton towel or cloth dampened with Recoat Conditioner and Prep Cleaner.

4. Abrade the floor once it has dried using two SPP's (one driving the other) so that the pad more effectively contours to the surface of the flooring. This will ensure abrasion of the edges next to any over wood and in the grain pattern optimizing adhesion of the finish topcoat. Beveled edges and any visibly un-abraded areas should be cleaned and abraded by hand.

5. Tack the floor again to remove dust using a wrung-out cotton towel or cloth dampened with Recoat Conditioner and Prep Cleaner.

6. When completely dry, apply a NewAge Sport brand floor finish immediately, following the label directions. Make sure the Recoat Conditioner and Prep Cleaner solution is completely dry before applying finish.